Install with confidence.
Easy to use, connect to each side of the cable.
9 LED's illuminate testing the complete series of 19 pins on the HDMI interface.
Selectively measures each sub circuit within the interface and displays a pass or fail function.
May be used for DVI cable assemblies. CEC LED will remain unlit.
ONE HDMI INPUT ON THE TRANSMITTER
ONE HDMI INPUT ON THE RECEIVER
CABLE FUNCTION IDENTIFICATION
Data Red: Streaming Digital for Red with multiplexed sound
Data Blue: Streaming Digital for Blue with multiplexed sound
Data Green: Streaming Digital for Green with multiplexed sound
Data Clock: Master clock for multiplexing with Red, Blue Green and sound data
CEC: Consumer Electronics Control (Future CE Control)
I2C Clock: Serial port timing output supporting HDCP
I2C Data: Serial Data for HDCP & EDID
+5 Volts: System Supply Voltage and Standby
Hot Plug: Announces Presence of HDMI source
Enclosures - ABS black plastic. Dimensions 2-1/2" x 4" x 1"
Requires 2 AA batteries, not included.

Next Generation Home Products proudly introduces the DCT 501 Cable Tester, allowing a "GO" or "NO GO" decision on the use of an HDMI cable. There are nineteen conductors making up the HDMI interface composing of nine discrete functions. The SES DCT 501 is designed to test each function individually.
The SES DCT 501 transmitter sends a controlled voltage through every conductor throughout the Cable interface. Where thereare a series of conductors that make up a defined function The Cable Tester will analyze these circuits as one. The SES DCT 501 receiver is equipped with nine LED's that illuminate when the function is verified. If any one of the LED's does not illuminate, the cable is defective.